Thank you for showing off one of my favorite easy staining products.
Staining raw wood cabinets.
I can adjust the darkness and depth easily that way.
There are two ways to go about it.
Remember stain is for the color of the cabinets.
If you use an oil based stain use an oil based polyurethane for a finish.
Never allow any stain to dry on the wood surface it will prevent the clear finish from adhering and cause other issues.
Fresh green wood stain cabinets stained a leafy deep green from sherwin williams would look amazing atop a rich black walnut wood floor.
Start with wood stain sealer.
I m so disappointed in the project source unfinished cabinets from lowes.
Over raw wood i get splotchiness but i love it over sealed wood.
In fact with the great deals that you can find on unfinished cabinetry there is really no reason not to tackle the.
Divide a test board into three sections.
You need to put on a finish.
Jennifer ott january 11 1970.
I dip it into the van of polyshades and wipe it on.
Thoroughly stir the wood stain before applying.
There are a few common tricks and techniques that will help you get that perfect factory finish.
It does not protect the wood.
Lightly sand all surfaces to be stained.
Pay attention to how long you leave the stain on the wood before wiping off any unabsorbed liquid.
Leave one section raw wipe full strength sealer on one section and wipe half strength sealer on the third section.
The longer the stain is left on the deeper and richer the color will be.
Use a rag or cloth instead of a sponge which may absorb the stain.
How you apply the stain onto the wood cross grain or with the grain is less important than applying plenty of it.
For consistent color use careful timing.
Test on a piece of scrap wood.
Cabinet finishing whether you re using paint stain oil urethane or something else is an easy fun job that doesn t require a ton of tools or years of experience.
We liked that way they looked and when i used a minwax wood conditioner it raised pieces of wood all along the whole piece then i tried a primer the same thing happened again raised wood always sanding between then i put the first coat of paint on raised wood again the amount of time i ve put.
Most unfinished cabinets come from the factory sanded smooth enough to stain but it is a good idea to lightly sand all surfaces with 220 grit sandpaper to remove any dirt that may have settled into the pores of the wood and to ensure that the surface is even and smooth.
Let it dry for about an hour and sand lightly with 220 grit paper.
8 stunning stain colors for kitchen cabinets transform raw wood for custom looking cabinetry with a stain that fills your need for color but lets the grain show through.
I usually apply it with a blue paper shop towel.
Apply two coats this will ensure your wood s protection.